Rugged Ethernet & Timing Solutions
The CR-6200-MIL Series is a fully rugged managed gigabit Ethernet switch and router specially designed to operate reliably in harsh climatically and noisy electrical demanding environments (e.g. high altitude, extreme shock, and vibration, wide temperatures, humidity, dust and water exposure, noisy EMI, dirty power) of military applications. The platform is an advanced and highly engineered switch/router that addresses complexity, enables modularity, and provides growth while delivering optimal performance for Space, Weight, Power and Cost (SWaP-C) constrained aircraft applications onboard helicopters and fixed-wing aircraft. The unit complies with the military environmental, EMC, and power input requirements.
CR-6200 MIL SERIES | 128pins – MILITARY ETHERNET SWITCH & ROUTER
| PTP | G – PTP GMC, S – PTP TC/SC |
|---|---|
| CONNECTORS | 19 – 2x 128 pins D38999 N and A keying for 24x 10/100/1000BASE-T, 1A – 2x 128 pins D38999 both with N keying for 24x 10/100/1000BASE-T and 4x 10G-T FAS-T connectors, 67 – 2x 128 pins 38999 N and A keying for 24x 1G-T and 4 10GbE Copper FAS-T |
| POWER CONNECTOR TYPE | N – 5 pin MMP, T – 4 pin and 2 coax D38999 |
| Ethernet ports | |
| 10/100/1000BASE-T 10GBASE-T |
24 4 |
| Switch protocols | |
| Standards | IEEE 802.3x for Flow control IEEE 802.3ad for LACP (Link Aggregation Control Protocol) IEEE 802.1D for STP (Spanning Tree Protocol) IEEE 802.1p for COS (Class of Service) IEEE 802.1Q for VLAN Tagging IEEE 802.1w for RSTP (Rapid Spanning Tree Protocol) IEEE 802.1s for MSTP (Multiple Spanning Tree Protocol) IEEE 802.1X for Authentication IEEE 802.1AB for LLDP (Link Layer Discovery Protocol) IEEE 1588 (PTPv1 and PTPv2) |
| MAC table | 32768 MAC addresses |
| Priority queues | 8 |
| Switch fabric properties | Store-and-forward and full wire speed on all ports |
| Security Features | Enable/disable ports, MAC based port security Port based network access control (802.1x) VLAN (802.1Q ) to segregate and secure network traffic. Radius centralized password management SNMPv3 encrypted authentication and access security |
| Management | HTTP/HTTPS, telnet/SSHv2, CLI and SNMP v1/v2/v3 |
| Built-in test | Built-in test procedure performed at boot time. Continuous BIT procedure when device is powered |
| Other protocols | IGMP snooping (up to 1024 multicast filters) Static multicast filter setting Port rate limiting DHCP TOS/Diffserv supported Quality of Service (802.1Q) for real-time traffic VLAN (802.1Q) with VLAN tagging and MVR Port configuration, status, statistics, monitoring, security |
| Router/Firewall protocols | |
| IPv4/IPv6 routing | BGPv4, BGPv6 OSPFv2 RIPv2 Static routes Policy based routing Equal cost multipath |
| VPN | SSL-based OpenVPN, OpenVPN client Auto configuration Site to site VPN (IPSec for IPv4 and IPv6) |
| Remote VPN (PPTP, L2TP, IPsec) | |
| Tunnels | PPPoE, GRE, IPIP, SIT, static L2TPv3, VXLAN |
| IP address management | Static DHCP server, DHCP client, DHCP relay Dynamic DNS, DNS forwarding DHCPv6 Server, DHCPv6 Client, DHCPv6 Relay |
| Firewall | Stateful inspection firewall Zone based firewall P2P filtering IPv6 firewalling Time- based firewall rules Rate limiting ICMP Type filtering Stateful failover |
| Management | Integrated CLI Telnet SSHv2 Radius SNMP Single configuration file |
| Additional security | Priority queuing Network emulator Round Robin Random/Weighted Random Classful queuing Ethernet header matching VLAN tag IPv6 address Port mirroring |
| Shaping | QoS policies as drop tail fair queue Traffic redirection |
| High availability | Stateful firewall /NAT failover VRRP Clustering Configuration replication IPSec VPN clustering Protocol fault isolation |
| Multicast | PIM-SM (for WAN routing), IGMP snooping and MVR |
| Flow accounting | NetFlow and sFlow |
| NAT | Source/Destination NAT Port forwarding One to one, one to many and many to many translations |
| Other I/O | |
| RS232 | 1 port, settings: 115200, N, 8, 1 (CLI console) |
| PPS | Pulse-Per-Second (PPS) output |
| IRIG-B | IRIG-B DC input, IRIG-B DC output (10V into 50Ohm load) and IRIG-B AM output |
| Connectors | |
| Ethernet copper connectors | FAS-TandD38999 |
| GPS antenna connector | Huber+Suhner QN coax connector (24-QMA-50-2-2) |
| Power connector | 5 pin MMP |
| Connector spacing | According to MIL-STD-1472F |
| Data Zeroization Support | |
| Data Zeroization | To erase Non-Volatile Flash Memory and Restore Board to Factory Default Config- uration. Available via HTTP and CLI |
| Power | |
| Power Consumption (Typ.) | 70W |
| Overload Current Protection | Yes |
| Reverse Polarity Protection | Yes |
| Power input | 28VDC (22-32VDC) |
| Hold-up | 100ms |
| Physical Characteristics | |
| Enclosure | Aluminum case |
| Dimension (W * D * H) | 250mm (W) x 148.5mm (D) x 106.4mm (H) / 9.84in (W) x 5.85in (D) x 4.19in (H) |
| Weight | 4700g / 10.362bs. |
| Surface finish | Powder paint on top of SurTec 650 |
| EMC/Enviromental | |
| Conducted Emission | MIL-STD-461F: CE101-4, Army and Navy ASW aircraft; MIL-STD-461F: CE102, 10KHz – 10MHz, power leads |
| Conducted Susceptibility | MIL-STD-461F/G: CS101, Power Leads; CS114, Bulk Cable Injection, 10 KHz – 200 MHz; CS115, Bulk Cable Injection, 10 KHz – 200 MHz; CS116, Damped Sinusoidal Transients, Cables and Power Leads, 10 KHz – 100 MHz; CS118, Personnel Borne Electrostatic Discharge (ESD) |
| Radiated Emission | MIL-STD-461F: RE101, Magnetic Field, 30Hz – 100KHz, Army; RE102, Electric Field, All aircraft types, Fixed wing internal conditions |
| Radiated Susceptibility | MIL-STD-461F: RS103, 2MHz-40MHz, 200V/m |
| Power input | MIL-STD-704F |
| Operational Temperature | MIL-STD-810G: 501.5, 502.5 and 503.5; RTCA DO-160G: chapter 4.5.2 and 4.5.4, [-40..+71]C◦ |
| Storage Temperature | MIL-STD-810G: 502.5; RTCA DO-160G: chapter 4.5.1 and 4.5.3, [-40..+85]C◦ |
| Altitude | MIL-STD-810G: 500.5, 85.000ft |
| Operational vibration | MIL-STD-810G: 514.6, procedure I (up to 10g) |
| Shock | MIL-STD-810G: 516.6, procedure V (40g, 11ms); 516.4, procedure 1 (30g, 11ms); RTCA DO-160G: chapter 7.5.2 (6g, 11ms); chapter 7.5.3 (20g, 11ms) |
| Acceleration loads | MIL-STD-810G: Method 513.6 (operational: 24g, ultimate load: 35.9g) |
FLIGHT-RATED ETHERNET SWITCHES
CM-6200 AER SERIES | 128pins – MANAGED AIRCRAFT ETHERNET SWITCH
FLIGHT-RATED ETHERNET SWITCHES
FLIGHT-RATED ETHERNET SWITCHES
FLIGHT-RATED ETHERNET SWITCHES
GROUND & SHIPBOARD ETHERNET SWITCHES
FLIGHT-RATED ETHERNET SWITCHES
FLIGHT-RATED ETHERNET SWITCHES
FLIGHT-RATED ETHERNET SWITCHES
CM-6200 AER SERIES | FAS T or FAS X – MANAGED AIRCRAFT ETHERNET SWITCH
